...XPS rigid insulation. It’s a great product; we have reservations about the climate impact as XPS foam has high green house gas emissions, but finding used stuff...
We live in Bellingham WA and our basement was built in the 70's. It has high humidity (70-80%RH) although I don't see any visible damp anywhere. The washer/drye...
...XPS with 4" studs and roxul insulation to give around r24 (local code). This is expensive and I'm not 100% on board because the basement is half above grade. I ...
I read in one of your articles when putting up rigid foam to Install two inches of rigid insulation board directly against concrete. A mold expert told me to p...
...XPS Foam Insulation & Styrofoam We always choose (and recommend) EPS over XPS due to the fact that XPS has much higher greenhouse gas emissions than EPS. S...
I have been reading so much on insulation ....and out of the foam boards I think eps might be the best to use, but not sure if the foil face would be good, may...
I want to first off thank you for taking the time to read this and hopefully provide some help. I've watched the great videos on here and just want to ensure I'...
...XPS or Mineral Wool to prevent rot in building envelopes.
...XPS insulation have switched blowing agents yet. So as it stands, any XPS rigid insulation board you purchase will still have an impact several hundred times wo...
...XPS rigid insulation boards I have a few questions that will help us pin down the best way forward for you - How old is the home? Is there an exterior membrane...
Eight years after our house was built, we noticed that the MDF baseboards in our finished basement became discoloured and swollen from potential moisture. We re...
I have an unfinished walkout basement with 3 sides at or below grade. The two sides of the house have poured concrete step foundation down toward the rear with ...
While searching to purchase EPS boards, which are very difficult to find here in QC, I've bumped into a 4' x 8' x 1" thick board, called GPS. Do you have a web...
...XPS against the foundation and framing an interior wall inside of that. Option 1 is to piece the XPS to follow the contour of the transition to the narrower bl...
An error occurred. Sorry for the inconvenience.
Close