...walls to protect the stone or concrete wall from freezing and cracking. Is that an option? If so read on here – How to properly insulate the exterior walls of ...
I live in east Texas and have a tiny home shell with wood 4x8 sheet siding. I want to put viny siding on. For insulation foam sheets on exterior can I use formu...
...walls, since the source of moisture that could damage the walls is not humidity in the interior air, it is moisture from the ground and concrete. The short stor...
...walls and insulated with Roxul insulation Batts I went to go do some electrical work today and pulled back a bath and noticed that there was a bunch of condensa...
...walls may be in reasonable shape. The wall assembly you mention – putting rigid foam insulation against foundation walls followed by a stud wall and Roxul / Roc...
My husband is finishing our basement and installed 1 inch foam insulation to the exterior wall before framing and then installing fiberglass insulation. When he...
...walls and the crack was so small that nothing comes through. Sorry for the rambling but I wanted to give you as much information as possible. Thanks for any hel...
The house will be subject to strong winds and rain, and a high level of humidity (often 100%). We have now installed a air heating floor (Legallet), the roof is...
...walls are concrete block and we have 2 sides done with interior plastic membrane to french drain and sump pump, one side exterior waterproofing, and one side wi...
...walls have pink fibre glass insulation covered with clear plastic and a black plastic border nailed into the concrete but the bottom half of the walls are left ...
All, I have what I think is an unusual problem and I’d like suggestions for the best way to address it. I have a below-grade “cinder block” basement wall that ...
...walls from the outside, that may give you some valuable tips as well. And the only other point I think you should keep in mind is that the junction between the ...
...walls (concrete block) at +/- 10% slope. Inside, I want to the best job I can, (without breaking up the concrete floor in the basement for an interior drainage ...
If so, how would the windows be installed? Also, once installed can I add stone and mortar to the stucco exterior? You could use Straw bale SIPs on the outside ...
...walls. That way you keep your stud wall dry and don’t have to go through this again in the future. And a question – what is your climate zone? Insulating old b...
I finished a basement for a contractor and what we did was put tar paper on the concrete walls the left about 3/4 to an inch of air space than a 2x4 wall I thin...
...walls to crack. Concrete block walls are not as strong as poured concrete, since they are only held together by the mortar between blocks.
...walls were just about touching the block walls and had no barrior between them. I now am going to put 4 new walls up (same as before 3 exterior, 1 dividing). I ...
An error occurred. Sorry for the inconvenience.
Close